Atlona AT PROHD88M SR Manuel d'utilisateur Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 14
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
www.atlona.com | toll free: 1-877-536-3976
For International: 1-408-962-0515
8
IR REMOTE CONTROL
VERY IMPORTANT:
If one of your Output devices is a projector or a display with a unique resolution your sources/source
which are/is connected to the switch might not send out a proper video format which will result image
to intermit or signal not show up on the display.
Solution: Make sure your DIP switch conguration is either DIP # 1 or # 2. Route the device in question
to the output in question. After that’s done, please perform the following operation: (Simultaneously
press and hold the “Output # (in question) and “FN Key” buttons for three seconds). You shall see the
following message to appear on your LED display: “MIX OK”
If you receive a “MIX FL” – please try this operation again.
The AT-PROHD88M-Sr comes with 16 button IR remote control, which could be
used to control the switcher when pointing at it or controlling the switcher from
a remote location by pointing the remote control to the IR Eye connected to the
HDMI receiver.
For users who would like to use a 3rd part IR remote control or IR remote sys-
tem, we recommend either learning IR codes off the remote or copying and
pasting the IR HEX code into the remote control software. The le with HEX
codes could be found on Atlona website under downloads for AT-PROHD88M-
SR.
There are 2 scenarios which codes to use:
• User will need to learn all 64 x codes in order to control each location
when pointing at the switcher
• User will only need to learn 8 x codes if there will be a separate remote
for each remote location
Note: The switcher can only accept and route IR signal which doesn’t exceed 38 KHz.
In other words, if you are trying to send IR signal from the remote location though
out HDMI receiver and the IR signal is higher than 38 KHz, the IR signal will not pass
though.
VERY IMPORTANT:
When connecting IR receivers and IR emitters, be very careful as if they are reversed the IR Eye will
burn-out and also may damage the IR module inside of the switch and Receiver.
TX – Connects to the Switch
RX – Connects to the HDMI Receivers
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire